![]() The Evapo-Rust isn’t the most inexpensive pick on our list, but based on its effectiveness and ease of use, it definitely gives you plenty of bang for your buck. Keep in mind, however, that if rust has already bled onto these materials and stained them, Evapo-Rust will not do much for removing these stains. The product does not expire and can be on items containing rubber, plastic, rubber, or fabric without damaging the material. This provides enough solution to remove about a 1/2 pound of pure dry rust. The Evapo-Rust rust remover is available in 1-gallon bottles. When finished, rinse off and dry the object, which should now look as good as new. You’ll know the product is done working when your water turns completely black. Then submerge it in the solution for anywhere between 30 minutes to 12 hours, depending on how heavy the rust is. Simply pour enough solution in a container to cover the rusty object you wish to treat. We love that this rust remover is easy to use. The active ingredient is a natural sulfur-bearing compound that works as effectively as other chemical ingredients that bind with metal ions without harmful acids or fumes. The organic, water-based rust remover works through selective chelation, which means it bonds specifically to the iron in rust, breaking it down without affecting the surrounding material. The Evapo-Rust rust remover will save your favorite antiques, cookware, and other metal items from unsightly corrosion caused by exposure to the elements. You'll be pleased how much more easily your workpieces will move over the bed.While mild enough to use on plastic and rubber, it won’t remove mild rust stains that may have accumulated on these materials over time. I'd apply a second coat of wax and buff it out again for good measure. Then buff it out by hand with a buffing pad or soft cloth. A haze is a good indicator that it's cool and dry enough. Apply a thin, even layer of paste wax and allow it to cool and dry. You want it warm to the touch but not hot. That will help drive out the moisture and make it easier to wax, and easier for the wax to penetrate. If you have any way to warm the metal above normal room temp (direct sunlight, halogen flood lamp, etc.) that would be good. Then wipe everything down with clean damp sponge or cloth to make sure you have all of the residue off. I'd then use a damp Scotch Brite pad to loosen it and wipe clean with a damp sponge or cloth. I would first try removing it with a relatively damp sponge, but if it is dried and that probably won't do it. "Pink or brown" sounds like there is a lot of Naval Jelly left, not just residue. It is a pink or brown very obvious discoloration.Bob, This may be the answer, but what I have I would most definately not describe as a white haze. Some folks use other products like Bosheild for this purpose. Once oxidation stops, the haze will disappear.Īfter the haze is gone and the acids are neutralized I would dry the surface thoroughly and treat it with an appropriate topcoat like paste wax. ![]() Simply alternate between hot and cold water rinses. The white haze occurs when small amounts of phosphoric and sulfuric acids oxidize. I used Naval Jelly Rust Dissolver and got a white “haze” on the item I was refinishing. Anyhow, does anyone know how to get this discoloration off? I have heard fine grit sandpaper and WD-40 from a couple of people, I have not tried this, is this the best way to go about this?Bob, ![]() Had I read the forum, I would have known this. It left a wierd discoloration on my jointer. I got some naval jelly and followed the instructions precisely. Before reading the forums, I went to HD to get something to remove some rust off a jointer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |